4310 tilt sterring wheel broken
jimbopa
Join Date: Jul 2003 Posts: 54 PA |
2002-05-27 39096
Poor desgin on the plastic steerring wheel, The lever that you push forward and pull back to tilt is stuck. The wheel wont budge. Poor design on this , only 10 hours.
Also when I back into my garage with the loader on and low rpms the thing seems to slip, doesnt seem to have power. The garage has a slight lit on the concrete so the front tire must get hung upo a bit, but we are only talking three inches. In four its fin, more rpms its fine. This is when I have the loader on the front no hoe on or ballast.
Suggestions on either issue appreciated.
Reply to | Quote Reply | Add Photo
4310 tilt sterring wheel broken
TomG
Join Date: Feb 2002 Posts: 5406 Upper Ottawa Valley |
2002-05-28 39105
The dealer probably has a solution for the steering wheel.
I'm thinking that the description of backing into the garage may be normal operation. As I understand, it’s in 2wd at low rpm and low speed, the front tires won't go over a concrete lip and the rear wheels spin. I assume the tractor has HST and the tires aren't loaded.
I'd think of it as a leverage problem. To go over a bump, enough work has to be done to lift the weight that's on the front axles the vertical distance of the bump. That work can be done over a short or a long time. The small diameter of the front tires in combination with a vertical edge on a lip means that the work has to be done with a lot of force over a short time--it's almost a vertical lift. Meanwhile, rear tires do not have a lot of traction with a loader mounted and little rear weight. If the rear wheels aren't actually spinning, HST pumps may not produce much pressure very low rpm's and the TX may be stalling.
I have gears and use my lowest range when maneuvering in sheds so I can keep the ground speed low and the rpm up. Low range with a HST probably works similarly. In addition, 4wd does work wonders, and I'm often surprised at how little traction there can be on the back wheels going down hills, without proper ballast etc.
....
Reply to | Quote Reply | Add Photo
4310 tilt sterring wheel broken
jimbopa
Join Date: Jul 2003 Posts: 54 PA |
2002-05-29 39130
Tech showed up and could not fix the tilt wheel or backhoe lift issue so its taken to the shop.
....
Reply to | Quote Reply | Add Photo
4310 tilt sterring wheel broken
bigbukhntr
Join Date: Jul 2003 Posts: 56 flower mound, texas |
2002-05-29 39138
Geez jim....has this been the tractor purchase from hell or what?? sorry to hear u are still having problems, but when u finally get it back, there couldnt possibly be anything left to go wrong is there? good luck ....
Reply to | Quote Reply | Add Photo
4310 tilt sterring wheel broken
DH83
Join Date: Posts: 1 |
2002-05-29 39151
I'm with you bigbuknut(is that how you say that?)I don't
know if I could handle all of jimbo's problems,I'm thinking
about canceling my 4310 order. ....
Reply to | Quote Reply | Add Photo
4310 tilt sterring wheel broken
keith rose
Join Date: Posts: 1 |
2002-05-29 39153
Go with the Boomers, there is to much electric crap on those new Deeres! They are trying to make them so us poor old boys can't work on them! Following along with the trend of new cars. Good Luck Jim! ....
Reply to | Quote Reply | Add Photo
Go Top
Share This